|
|
|
|
|
 |
|
PAQUETES > TCC10 |
| |
|
| |
 |
|
The units shall be
horizontal airflow as shipped and convertible to downflow. All
units shall be factory assembled, piped, internally wired and
fully charged with R-22. Units shall be UL listed and carry a UL
label. All units shall be factory run tested to check cooling
operation, fan and blower rotation and control sequence. Units
shall be designed to operate at ambient temperatures between
115º F. and 55º F. in cooling as manufactured. Cooling
performance shall be rated in accordance with ARI standards.
|
|
|
|
|
| |
Unit
Casing
All components shall be mounted in a weather resistant steel
cabinet with an enamel finish.
Access panels shall be provided for unit controls and indoor
coil and fans. Indoor air section compartment shall be
completely insulated with fireproof, permanent, odorless, foil
faced glass fiber material. Knockouts shall be provided for
utility and control connections.
Drain connections shall be provided to accommodate indoor water
runoff.
Compressor
The compressor shall be a hermetically sealed, high efficiency
Climatuff® compressor. Internal overcurrent and over temperature
protection, internal pressure relief shall be standard.
Refrigeration System
All units shall have capillary refrigerant control. Service
pressure tap ports, and a refrigerant line filter shall be
standard.
Indoor and Outdoor Coils
Coils shall be internally finned or smooth bore 3/8" copper
tubes mechanically bonded to configured aluminum plate fin as
standard.
Evaporator coil leak and pressure tested to 200 psig; condenser
coil tested to 450 psig.
Indoor Fan
The indoor fan shall be a forward curved, centrifugal-type fan
with a multiple-speed, direct drive motor. Motor is permanently
lubricated and shall have built-in overload protection. |
|
|
| |
FICHA TÉCNICA
|
|
|
 |
|
| PAQUETES |
|
|
|
|
|
